Removing Dc Controller Pcb - Canon imagePRESS 1135 Series Service Manual

4
Parts Replacement and Cleaning > PCB > Removing DC Controller PCB

Removing DC Controller PCB

With a service support tool (SST), You upload the backup ("SramDCON.bin") of the DC controller PCB.
(Except the case that is impossible of upload by DC controller PCB trouble.)
<Preparation>
1) Remove Rear Left Cover.
(Refer to page 4-55)
2) Open the Controller Box Unit.
(Refer to page 4-57)
1) Remove the harness and remove PCB cover.
• 6 wire saddles
• 10 screws (loose)
• 1 screw (remove)
2) Remove the DC controller PCB.
• 6 screws
• connectors on PCB (31 pc)
x7
x31
x6
4 Parts Replacement and Cleaning > PCB > Removing DC Controller PCB
Wire harness
PCB cover DC controller PCB
4-354
F-4-809
4-354