Removing Developing Assembly - Canon imagePRESS 1135 Series Service Manual

4
Parts Replacement and Cleaning > Periodic Replacing Parts, Durable Parts, Cleaning Parts > Removing Developing Assembly

Removing Developing Assembly

<Preparation>
1) Open the Front Left Cover and the Front Right
Cover.
(Refer to page 4-54)
2) Remove Process Unit Cover.
(Refer to page 4-71)
3) Remove Primary Charging Assembly.
(Refer to page 4-158)
4) Pull Out Process Unit.
(Refer to page 4-72)
Caution :
When replacing this part, be sure to
perform the "operation after replacing
the developing assembly".
3) Place the paper on the photosensitive drum.
Caution :
Be careful not to expose the photosensitive drum to the light.
4 Parts Replacement and Cleaning > Periodic Replacing Parts, Durable Parts, Cleaning Parts > Removing Developing Assembly
1) Remove the 2 screws , hold the grip and open the process unit upper lid.
2) Turn the lock lever in the direction of the arrow and lock to lock the process unit upper lid.
x2
Paper
F-4-372
Process unit upper lid
4) Place the paper on the position where to place
the developing assembly.
4-185
Lock lever
F-4-371
4-185