Cleaning Procedure During Developing Assembly Replacement - Canon imagePRESS 1135 Series Service Manual

4
Parts Replacement and Cleaning > Periodic Replacing Parts, Durable Parts, Cleaning Parts > Cleaning Procedure During Developing Assembly Replacement

Cleaning Procedure During Developing Assembly Replacement

<Preparation>
1) Open the Front Left Cover and the Front Right
Cover.
(Refer to page 4-54)
2) Remove Process Unit Cover.
(Refer to page 4-71)
3) Remove Primary Charging Assembly.
(Refer to page 4-158)
4) Pull Out Process Unit.
(Refer to page 4-72)
5) Remove Developing Assembly.
(Refer to page 4-185)
2) With holding the pre-primary transfer magnetic plate , push the claw to rear and lower the front side to remove.
Caution :
Be careful not to drop
the toner stack on the
pre-primary transfer
magnetic plate when
removing it.
4 Parts Replacement and Cleaning > Periodic Replacing Parts, Durable Parts, Cleaning Parts > Cleaning Procedure During Developing Assembly Replacement
Caution :
Be careful not to damage the drum at cleaning.
Pre-primary transfer magnetic plate
1) Clean the [A] part of developing assembly lower plate with vacuum.
Drum
F-4-388
4-193
[A]
F-4-389
F-4-390
4-193