Canon imagePRESS 1135 Series Service Manual page 729

■ Downloading the System Software (all overwriting)
[3] : Upgrade (Overwrite all)
The system software in the USB device will overwrite the software on the HDD regardless
of the version of the latter.
Unlike menu item [1], however, the machine will not restart on its own at the end of
downloading. When the power is turned off and then back on manually, the machine starts
writing the system software.
Procedure
1) Check to see that the Execute / Memory lamp on the control panel is off, and turn off
the power of the machine as described below.
1-1) Hold down the power switch on the control panel for 3 sec or more.
1-2) Shut down the machine by following the instruction on the control panel.
The main power switch will turn off automatically.
2) Connect the USB device to the USB port.
3) Start the machine in appropriate download mode.
4) Press the key on the control panel.
[3] - > [0] : execute download / other that [0] : go back to Menu screen
While downloading is under way, the control panel shows its progress.
At the end of downloading, a message will appear asking you to press a key.
6
Troubleshooting > Version Upgrade > Version Upgrade using USB > Downloading the System Software (all overwriting)
F-6-107
6 Troubleshooting > Version Upgrade > Version Upgrade using USB > Downloading the System Software (all overwriting)
5) Press the appropriate key.
If the machine is in normal mode, the shut-down sequence will start.
6) When a message appears asking you to turn off the power, turn off the main power switch.
7) Remove the USB device.
8) Turn the main power switch back on.
Upon start-up, the machine starts writing the system software to the system area of the
HDD or the flash ROM.
At the end of writing, a message will appear asking you to turn off.
9) After 10 sec from when the main power switch of the machine turns off, turn on the main
power switch.
6-62
F-6-108
F-6-109
6-62