Canon imagePRESS 1135 Series Service Manual page 431

4
Parts Replacement and Cleaning > Periodic Replacing Parts, Durable Parts, Cleaning Parts > Replacing Primary Charging Wire (right)
8) Clean the grid surface (front and back) of primary charging assembly with lint-free paper moistened with alcohol.
Grid surface (front)
9) Since the primary charging assembly is replaced on charging wire basis, use the dedicated
torsion spring for charging wire (97-5527) [A].
Caution :
Be careful not to use the spring
[B] installed to the primary
charging wire (right) unit.
4 Parts Replacement and Cleaning > Periodic Replacing Parts, Durable Parts, Cleaning Parts > Replacing Primary Charging Wire (right)
10) Unroll the charging wire by approx. 5cm from the charging wire reel of 0.06mm wire diameter
11) Cut the edge (extra wire) of the twisted charging wire with a nipper etc.
12) Hook the loop on the stud.
Spring [B] Spring [A]
F-4-322
Grid surface (back)
and make a loop with 2mm diameter at the end.
MEMO :
To make a loop easily, wind the charging wire on the hex key once, turn the hex key 3
to 4 times and twist the charging wire.
Stud
Charging wire
(FRONT)
Charging wire reed
F-4-321
(REAR)
F-4-323
4-167
4-167