Canon imagePRESS 1135 Series Service Manual page 693

● How to observe the behavior of paper at the pick-up assembly
1) Pull out the deck of the main body and turn off the main power.
2) Remove the 2 screws and detach the internal cover [1].
3) Loosen the 5 screws that fix the deck front cover [1].
6
Troubleshooting > Feeding Failure > Multiple Feeding > Fan level adjustment
F-6-26
F-6-27
6 Troubleshooting > Feeding Failure > Multiple Feeding > Fan level adjustment
4) Remove the 1 screw on the right side of the deck and detach the cable cover [1].
5) Remove the 3 wire saddles [1] and 1 edge saddle [2], and roll out the cable [a].
Then, attach the 3 wire saddles and 1 edge saddle again.
CAUTION :
• Be careful not to make the cable come in contact with the edge of the plate, etc. and
broken.
• Do not disconnect the connector. If it is disconnected When the power is ON, Force
shutdown is required.
6-26
F-6-28
F-6-29
6-26