Canon imagePRESS 1135 Series Service Manual page 706

■ Installing the System Software (SST - > USB)
Here, you will be copying the system software from the SST to a USB device.
MEMO :
If the capacity of system software exceeds the CD capacity, the system software will be
recorded to the system CD in the compression file format.
In this case, after extracting the compression file, register it in the SST (Service Support
Tool).
Preparatory Work
Requirements:
• PC installed with SST version 4.04 or later
• USB device (*)
*: USB Requirements
Interface: USB 1.1 or higher (USB 2.0 or recommended)
Capacity: 1 GB or more recommended (A set of system software is in excess of 512 MB.)
Format: FAT (FAT16), FAT32 (It must not be NTFS or HFS.)
single partition (There must not be multiple partitions.)
CAUTION :
You cannot use a security-protected USB device. Be sure to remove the protection
before use.
Procedure
1) Start up the PC.
2) Connect the USB device to the USB port of the PC.
3) Start up the SST.
6
Troubleshooting > Version Upgrade > Making Preparations > Installing the System Software (SST - > USB)
6 Troubleshooting > Version Upgrade > Making Preparations > Installing the System Software (SST - > USB)
4) Click the USB icon on the Target Selection screen.
Service Support Tool DLM0 (Ver. X.XX E)
Target Selection CONTROL
Select the target.
Click a button to execute.
MFP
MFP
Reg ister Firmw are
USB
De lete Firmwa re
De le te Backu p Data
USB Syste m Mana geme nt
c:
Start Assist Mode
5) Select the drive (removable disk drive) to which the USB device has been connected.
Service Support Tool DLM0 (Ver. X.XX E)
Target Selection CONTROL
Select the target.
Click a button to execute.
MFP
Exp ort Firmwa re
MFP
Reg ister Firmw are
USB
De lete Firmwa re
De le te Backu p Data
USB Syste m Mana geme nt
c:
Select the destinate drive.
Model List
Select a model to connect
CONNECT
START
EXIT
F-6-46
Export Firm Selection
Select the destinate drive.
Series
Version
Firmware registration status
START
CANCEL
EXIT
F-6-47
6-39
6-39