Canon imagePRESS 1135 Series Service Manual page 728

While downloading is under way, the control panel shows its progress.
MEMO :
If the system software on USB device is the same or older than that on HDD, the
message whether or not to overwrite is displayed each time. Press the key on the
control panel.
• [0] : overwrite / other than [0] : do not overwrite
At the end of downloading, a message will appear asking you to press a key.
5) Press any key.
In case of normal mode, shutdown sequence is executed.
6) When a message appears asking you to turn off the power, turn off the main power switch.
7) Remove the USB device.
8) Turn on the main power switch.
Upon start-up, the machine starts to write the system software to the system area of the
HDD or the flash ROM.
At the end of writing to the HDD, a message will appear asking you to turn off.
6
Troubleshooting > Version Upgrade > Version Upgrade using USB > Downloading the System Software (Confirmation execution when version is downed the same version)
F-6-104
F-6-105
6 Troubleshooting > Version Upgrade > Version Upgrade using USB > Downloading the System Software (Confirmation execution when version is downed the same version)
9) After 10 sec from when the main power switch of the machine turns off, turn on the main
power switch.
6-61
F-6-106
6-61