Canon imagePRESS 1135 Series Service Manual page 727

6
While downloading is under way, the control screen shows its progress.
At the end of the downloading, the machine restarts on its own to start writing to the
system area of the HDD or the flash ROM.
At the end of writing to the HDD, a message will appear asking you to turn off and then
back on the power.
5) Turn off the main power switch.
6) Remove the USB device.
7) Turn the main power switch back on.
6
Troubleshooting > Version Upgrade > Version Upgrade using USB > Downloading the System Software (Confirmation execution when version is downed the same version)
F-6-100
F-6-101
F-6-102
Troubleshooting > Version Upgrade > Version Upgrade using USB > Downloading the System Software (Confirmation execution when version is downed the same version)
■ Downloading the System Software (Confirmation execution
when version is downed the same version)
[2] : Upgrade (w Confirmation)
System software on HDD and that on USB device are compared and if the system software
on USB device is newer than that on HDD, it will be downloaded in the temporary storage
area on HDD.
If the system software on USB device is the same or older than that on HDD, the message
whether or not to overwrite is displayed.
Unlike menu [1], the machine does not restart automatically after download is complete.
Turn OFF / ON manually to execute the writing of the system software.
Procedure
1) Check to see that the Execute / Memory lamp on the control panel is off, and turn off
the power of the machine as described below.
1-1) Hold down the power switch on the control panel for 3 sec or more.
1-2) Shut down the machine by following the instruction on the control panel.
The main power switch will turn off automatically.
2) Connect the USB device to the USB port.
3) Start the machine in appropriate download mode.
4) Press the key on the control panel.
[2] - > [0] : execute download / other than [0] : go back to Menu screen
6-60
F-6-103
6-60