Canon imagePRESS 1135 Series Service Manual page 698

● Explanation on setting range
If the setting value in user mode is decreased from 0 to -5 (5 levels), the setting value in the
paper feed correction table when making 2-sided prints becomes 0 as shown below.
When the setting value is 5, the upper limit is 10 and the lower limit is 0.
Even though the setting value is changed in user mode, any value that exceeds the upper/
lower limit cannot be set.
Non-coated paper
Before change
2-sided Paper weight
250 mm 75% to 100%
or more in
50% to 74%
paper width
25% to 49%
(landscape)
0% to 24%
Less than 75% to 100%
250 mm in
50% to 74%
paper width
25% to 49%
(portrait)
0% to 24%
Limit value
6
Troubleshooting > Feeding Failure > Remedy against 0112 Jam > User Mode and Machine Operation
After change
52 to 63 52 to 63
5 0
6 1
7 2
8 3
6 6
7 7
8 8
9 9
10 10
T-6-16
6 Troubleshooting > Feeding Failure > Remedy against 0112 Jam > User Mode and Machine Operation
● Adjustment procedure
Perform paper feed adjustment at 2-sided printing by following the procedure shown below.
MEMO :
Paper feed adjustment with the following conditions is shown here: non-coated paper,
250 mm or more in paper width (landscape), 75% to 100% of image duty, 60 g paper
weight and other environments.
Display of paper feed adjustment at 2-sided printing
1) Press (Additional Functions) -> [System Settings] -> [Paper Type Management Settings].
2) Select a paper type to edit from the list, and press [Details/Edit].
3) Press [Change] of [Paper Feed Adjustment at 2-sided Printing].
Paper feed adjustment at 2-sided printing is displayed.
4) Prepare the paper feed correction table when making 2-sided prints.
With the correction table, check that the feed setting is 5. Then, check the adjustable range.
Adjustable range is as follow: 5 levels in low direction, 5 levels in high direction.
6-31
F-6-36
6-31