Canon imagePRESS 1135 Series Service Manual page 730

■ Formatting the HDD
CAUTION :
This function is available only when the machine is in safe mode.
[4] : Format HDD
Use it to format the HDD for BOOTDEV partition.
Procedure
1) Check to see that the Execute / Memory lamp on the control panel is off, and turn off
the power of the machine as described below.
1-1) Hold down the power switch on the control panel for 3 sec or more.
1-2) Shut down the machine by following the instruction on the control panel.
The main power switch will turn off automatically.
2) Connect the USB device to the USB port.
3) Start the machine in safe mode. (While pressing 2 + 8, turn ON the main power
switch.)
4) Press the key on the control panel.
[4] - > [0] : go to Partition Selection screen / other that [0] : go back to Menu screen
6
Troubleshooting > Version Upgrade > Version Upgrade using USB > Formatting the HDD
F-6-110
6 Troubleshooting > Version Upgrade > Version Upgrade using USB > Formatting the HDD
5) Press the key on the control panel.
[1] - > [0] : execute BOOTDEV formatting / other than [0] : go back to Menu screen
[C] : go back to Menu screen
At the end of formatting, a message will appear asking you to press a key.
6) Press any key to go back to the Menu screen.
7) Start downloading the system software.
Refer to the Downloading Procedure (Single) for details.
6-63
F-6-111
F-6-112
6-63