2
Technology > eM Controller-E1 > Settings procedures
When
is pressed, detailed information is displayed.
The following settings in service mode must not be change unless there are specific
instructions to do so. Changing these values will cause error in communication with UGW.
2
Technology > eM Controller-E1 > Settings procedures
c. Select Service mode > COPIER > Function > INSTALL > COM-TEST and press [OK]. This
initiates the communication test between the device and the UGW. If the communication is
successful, OK! is displayed. If NG! (FAIL) appears, refer to the Troubleshooting guide and
repeat until OK! is displayed.
F-2-276
F-2-277
2-186
F-2-278
2-186