Settings Procedures - Canon imagePRESS 1135 Series Service Manual

2
Technology > eM Controller-E1 > Settings procedures

Settings procedures

To monitor an iR device with e-Maintenance/ imageWARE Remote, the following settings are
required.
(1) Advance confirmation
Confirm with the UGW administrator that the device to be monitored with e-Maintenance/
imageWARE Remote is registered in the UGW.
(2) Advance preparations
Interview the user's system administrator in advance to find out the following information
about the network.
Information item 1
IP address settings
• Automatic setting (DHCP, RARP, BOOTP)
• Manual setting IP address, subnet mask and gateway address to be set
Information item 2
Is there a DNS server in use?
• If there is a DNS server in use, find out the following.
• Primary DNS server address
• Secondary DNS server address
Information item 3
Is there a proxy server?
• If there is a proxy server in use, find out the following.
• Proxy server address
Information item 4
Is proxy server authentication required?
• If proxy server authentication is required, find out the following.
• User name and password required for proxy authentication
• Port No. for proxy server
2 Technology > eM Controller-E1 > Settings procedures
(3) Network settings
Based on the results of the information obtained in (2) Advance preparations, make the iR
device network related settings in accordance with the following procedures.
a. Additional Functions > System administration settings > Network settings > TCP/ IP
settings > IPv4 settings > IP address settings.
b. Set the IP address, based on the information obtained under (2) Advance preparations,
Information item 1, described above.
• For automatic acquisition, select from [DHCP], [RARP], [BOOTP].
• For manual setting, set the IP address, subnet mask and gateway address.
c. Press [OK].
d. Press [Close].
e. Additional Functions > System administration settings > Network settings > TCP/ IP
settings > DNS settings > DNS server address settings.
2-183
F-2-269
2-183