Canon imagePRESS 1135 Series Service Manual page 125

2
Technology > Fixing System > Various Types of Control > Fixing temperature control
● Fixing Cleaning Web Drive Control/Level Detection
Remove the residual toner remained on the fixing roller with a cleaning web (containing
silicon oil) to prevent fixing off-set.
Timing
During printing Large size
Small size
At jam recovery 1) It is detected that the temperature of the fixing roller reached 180 degree C.
2) Move the web for 100 times. (Obtain a clear web surface.)
3) Continue to move the web while driving the fixing roller.
(For 60 sec idle rotation)
Operation
The web is taken up when the web solenoid (SL2) is turned on.
SL2
Related Service Mode
• Adjustment of the number of fixing solenoid drive in jam recovery sequence (0 - 100)
COPIER >OPTION > BODY > FX-JAM-W
• Adjustment of the time of idle rotation in jam recovery sequence (0 - 60 sec.)
COPIER >OPTION > BODY > FX-JAM-I
2 Technology > Fixing System > Various Types of Control > Fixing temperature control
Once in two prints
Once in four prints
T-2-73
F-2-105
● Fixing cleaning web level detection
This detects that the low remaining level of fixing cleaning web.
Description
There is a cut-off on the edge of the web and the flag falls on the cut-off so that the fixing
cleaning web present sensor can detect it.
Web warning:
Detected by the fixing cleaning web present sensor (PS14)
If warning massage is displayed: it is necessary to replace the fixing web.
Web is empty:
Is detected by the fixing cleaning web present sensor, based on web solenoid ON numbers
(5200 times)
Service error display: E005-0001
Related Error Code
• Error because the fixing web is empty
E005-0001: fixing web has already been pulled for 5200 times after the fixing cleaning
web present sensor (PS14) is ON.
Web
Sensor flag
2-77
Link arm
PS14
Fixing cleaning web
present sensor
Link arm
F-2-106
2-77