Iot Remain Registration Jam - Xerox Phaser 6500 Service Manual

Error Messages and Codes

IOT Remain Registration JAM

Applicable Error Code
3-136
• 077-901
Troubleshooting Reference Table
Applicable Parts
Left Side Harness Assy (PL3.1.18)
■
Registration Input Actuator
■
(PL3.2.11)
Registration Sensor (Sensor Photo)
■
(PL3.2.13)
MCU Board (SFP PL8.2.13; MFP
■
PL8.3.6)
Feeder Assy. (PL 3.1.98)
■
Drive Clutch Assy. (PL 3.1.97)
■
Troubleshooting Procedure
Step Actions and Questions
1 Check the error.
Replace to known good paper.
Does the error still occur when
printing?
2 Open the Front Cover and check the
Registration Rollers.
Is the metal roller pressed against the
rubber roller by the spring pressure?
3 Perform the first part of the procedure
"Registration Clutch" on page 4-33 to
check the Registration Clutch.
Do you hear a click when the clutch is
energized?
4 Perform the procedure "Registration
Sensor" on page 4-22 to check the
Registration Sensor for operation.
Does the number on the screen
increase by one when you operate the
Registration Input Actuator?
5 Remove the Lower Chute Assembly
(page 8-84; PL3.2.27) to check the
shape and operation of the
Registration Input Actuator.
Are the shape and operation normal?
Xerox Internal Use Only
http://www.manuals4you.com
Wiring and Plug/Jack Map References
"Map 2 - SFP Laser Unit and Feeder" on
■
page 10-7
"Map 4 - SFP MCU Board" on
■
page 10-9
"Map 7 - MFP Laser Unit and Feeder"
■
on page 10-16
"Map 9 - MFP MCU Board and HVPS"
■
on page 10-18
"SFP Media Feed" on page 10-27
■
"MFP Media Feed" on page 10-40
■
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Replace the
MCU Board.
(SFP,
page 8-138;
MFP,
page 8-160)
Go to step 6.
Phaser 6500/WorkCentre 6505 Service Manual
No
Complete.
Replace Feeder
Assy. (SFP,
page 8-72;
MFP,
page 8-73).
Replace the
Drive Clutch
Assy.
(page 8-48).
Go to step 5.
Reseat the
Registration
Input Actuator.
(page 8-77)
If broken or
deformed,
replace it.