024-917 Stacker Tray Staple Set Over Count Rap - Xerox WorkCentre 5222 Service Manual

A
Y N
Repair the open circuit or short circuit.
Replace the Stacker Motor (PL 22.8). If the problem persists, replace the Finisher PWB
(PL 22.7).
Replace the Finisher PWB (PL 22.7). If the problem persists, replace the MCU PWB
Launch Version
WorkCentre 5225, 5230

024-917 Stacker Tray Staple Set Over Count RAP

The number of stapled copies exceeded the capacity of the Stacker Tray.
Initial Actions
• Refer to BSD 12.9.
(PL 9.1).
Procedure
Check the connection of each Finisher PWB connector. The connectors are connected cor-
rectly.
Y N
Connect the connectors.
Turn on the power again. [024-917] reoccurs.
Y N
End
Replace the Finisher PWB
February, 2008
2-345
(PL 22.7). If the problem persists, replace the MCU PWB
024-916, 024-917
(PL 9.1).
Status Indicator Raps