Subaru Legacy 2003 Service Manual page 2782

3) Place a thickness gauge between ABS sensor's
pole piece and tone wheel's tooth face. After stan-
dard clearance is obtained over the entire perime-
ter, tighten ABS sensor on housing to specified
torque.
ABS sensor standard clearance:
0.3 — 0.8 mm (0.012 — 0.031 in)
Tightening torque:
33 N·m (3.3 kgf-m, 24 ft-lb)
CAUTION:
Check the marks on the harness to make sure
that no distortion exists.
Model
Except OUTBACK
OUTBACK
NOTE:
If the clearance is outside specifications, adjust the
gap using spacer (Part No. 26755AA000).
4) After confirmation of the ABS sensor clearance,
connect connector to ABS sensor.
5) Connect connector to battery ground cable.
FRONT ABS SENSOR
ABS00142
LH RH
Yellow White
Brown Light blue
C: INSPECTION
1. ABS SENSOR
1) Check pole piece of ABS sensor for foreign par-
ticles or damage. If necessary, clean pole piece or
replace ABS sensor.
2) Measure ABS sensor resistance.
Terminal No.
1 and 2
CAUTION:
If resistance is outside the standard value, re-
place ABS sensor with new one.
NOTE:
Check ABS sensor cable for discontinuity. If neces-
sary, replace with a new one.
ABS-13
2 1
ABS00143
Standard
1.25±0.25 kΩ
ABS