Subaru Legacy 2003 Service Manual page 2794

4 PERFORM THE GENERAL DIAGNOSTICS.
1) Inspect using "General Diagnostics Table".
<Ref. to ABS-149, General Diagnostics
Table.>
2) Perform the clear memory mode. <Ref. to
ABS-22, WITHOUT SUBARU SELECT
MONITOR, OPERATION, Clear Memory
Mode.>
3) Perform the inspection mode. <Ref. to
ABS-21, Inspection Mode.>
Calling up the diagnostic trouble code
(DTC). <Ref. to ABS-19, Read Diagnostic
Trouble Code (DTC).>
Is only the start code displayed?
5 PERFORM THE DIAGNOSIS.
1) Inspect using "Diagnostics Chart with Diag-
nostic Connector".<Ref. to ABS-28, Diag-
nostics Chart with Diagnosis Connector.>
NOTE:
For diagnostic trouble code (DTC) list, refer to
"List of Diagnostics Trouble Code (DTC)". <Ref.
to ABS-24, WITHOUT SUBARU SELECT
MONITOR, LIST, List of Diagnostics Trouble
Code (DTC).>
2) Repair trouble cause.
3) Perform the clear memory mode. <Ref. to
ABS-22, WITHOUT SUBARU SELECT
MONITOR, OPERATION, Clear Memory
Mode.>
4) Perform the inspection mode. <Ref. to
ABS-21, Inspection Mode.>
5) Calling up the diagnostic trouble code
(DTC). <Ref. to ABS-19, Read Diagnostic
Trouble Code (DTC).>
Is only the start code displayed?
2. WITH SUBARU SELECT MONITOR
CAUTION:
Remove foreign matter (dust, water, etc.) from the ABSCM&H/U connector during removal and instal-
lation.
NOTE:
• To check harness for broken wires or short circuits, shake it while holding it or the connector.
• Check list for interview. <Ref. to ABS-25, WITH SUBARU SELECT MONITOR, LIST, List of Diagnostics
Trouble Code (DTC).>
1 CHECK PRE-INSPECTION.
1) Ask the customer when and how the trou-
ble occurred using interview checklist.
<Ref. to ABS-5, Check List for Interview.>
2) Before performing diagnosis, inspect unit
which might influence the ABS problem.
<Ref. to ABS-8, INSPECTION, General
Description.>
Is unit that might influence the ABS prob-
lem normal?
BASIC DIAGNOSTIC PROCEDURE
Step
Step
Value
Only the start code displayed. Complete the
Only the start code displayed. Complete the
Value
Component part is normal.
ABS-3
ABS (DIAGNOSTICS)
Yes
Go to step 5.
diagnosis.
Inspect using
diagnosis. "Diagnostics Chart
with Diagnostic
Connector". <Ref.
to ABS-28, Diag-
nostics Chart with
Diagnosis Con-
nector.>
Yes
Go to step 2. Repair or replace
each unit.
No
No