Subaru Legacy 2003 Service Manual page 2786

4) Place a thickness gauge between ABS sensor's
and tone wheel's tooth face. After standard clear-
ance is obtained over the entire perimeter, tighten
ABS sensor on rear arm to specified torque.
ABS sensor standard clearance:
0.44 — 0.94 mm (0.0173 — 0.0370 in)
Tightening torque:
33 N·m (3.3 kgf-m, 24 ft-lb)
CAUTION:
Check the marks on the harness to make sure
that no distortion exists.
Mark
NOTE:
If the clearance is outside specifications, adjust the
gap using spacer (Part No. 26755AA000).
5) After confirmation of the ABS sensor clearance,
connect connector to ABS sensor and install fuel
tank cover.
6) Connect connector to battery ground cable.
REAR ABS SENSOR
LH RH
Yellow White
ABS00163
C: INSPECTION
1. ABS SENSOR
1) Check pole piece of ABS sensor for foreign par-
ticles or damage. If necessary, clean pole piece or
replace ABS sensor.
2) Measure ABS sensor resistance.
Terminal No.
1 and 2
CAUTION:
If resistance is outside the standard value, re-
place ABS sensor with new one.
NOTE:
Check ABS sensor cable for discontinuity. If neces-
sary, replace with a new one.
ABS-17
2 1
ABS00143
Standard
1.25±0.25 kΩ
ABS