ABS (DIAGNOSTICS)
9. Clear Memory Mode
A: OPERATION
1. WITHOUT SUBARU SELECT MONITOR
1) After calling up a diagnostic trouble code (DTC),
disconnect diagnosis connector terminal 8 from di-
agnosis terminal.
( 2 )
(1) Diagnosis connector
(2) Diagnosis terminal
(3) 8 terminal
(4) 5 terminal
2) Repeat 3 times within approx. 12 seconds; connecting and disconnecting terminal 8 and diagnosis termi-
nal for at least 0.2 seconds each time.
Diagnostic trouble code (DTC) indication mode
ABS warning lamp
Terminal 8
NOTE:
After diagnostics is completed, make sure to clear memory. Make sure only start code (11) is shown after
memory is cleared.
2. WITH SUBARU SELECT MONITOR
Refer to SUBARU SELECT MONITOR for information about how to clear diagnostic trouble codes (DTC).
<Ref. to ABS-16, Subaru Select Monitor.>
CLEAR MEMORY MODE
( 1 )
( 3 )
( 4 )
ABS00291
Memory erase mode
GND(Low level)
0.2 sec
0.2 sec or more
or more
12 sec or less
ABS-22
GND open (High level)
1.5 sec
ABS00117