Mirroring-Group Monitor-Slot - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Mirroring
Description
Use the mirroring-group monitor-port command to configure the destination port.
Use the undo mirroring-group monitor-port to remove the configuration of the
destination port.
Note the following when you configure the destination port:
LACP must be disabled on the mirroring destination port and STP is
recommended to be disabled on the port.
The destination port for remote mirroring must be an Access port.
After a port is configured as a reflector port, the switch does not allow you to
change the port type and its default VLAN ID.
Example
# Configure GigabitEthernet1/0/4 as the source port and monitor all packets received
via this port.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] mirroring-group 1 monitor-port Gigabitethernet1/0/4

1.1.9 mirroring-group monitor-slot

Syntax
mirroring-group group-id monitor-slot slot-number
undo mirroring-group group-id monitor-slot slot-number
View
System view
Parameter
group-id: Group number of a mirroring group, in the range of 1 to 20.
slot-number: Number of the slot where the mirroring destination LPU resides.
Description
Use the mirroring-group monitor-slot command to configure the destination
mirroring LPU. In order to mirror a port to a LPU, the mirroring group must be active.
Use the undo mirroring-group monitor-slot command to remove the configured
mirroring destination LPU.
Example
# Specify the module in slot 4 as the mirroring destination LPU.
1-10
Chapter 1 Mirroring Commands