Peer - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Routing Protocol
View
Interface view
Parameter
seconds: LSA transmission delay on an interface. It ranges from 1 to 3,600 and
defaults to 1 (in seconds).
Description
Use the ospf trans-delay command to configure the LSA transmission delay on an
interface.
Use the undo ospf trans-delay command to restore the default LSA transmission
delay on an interface.
LSA ages in the "link state database" (LSDB) of the router as time goes by (1 added
every second), but it does not age during network transmission. Therefore, it is
necessary to add a period of time set by this command to the aging time of LSA before
transmitting it.
Example
# Specify the trans-delay of transmitting LSA on the interface Vlan-interface 10 as 3
seconds.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] interface Vlan-interface 10
[3Com-Vlan-interface10] ospf trans-delay 3

3.1.42 peer

Syntax
peer ip-address [ dr-priority dr-priority-value ]
undo peer ip-address
View
OSPF view
Parameter
ip-address: IP address of the peer.
dr-priority-value: Value of the corresponding priority of a neighbor in the NBMA
network. It ranges from 0 to 255 and defaults to 1.
Chapter 3 OSPF Configuration Commands
3-47