Secondary Authentication - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – AAA, RADIUS, HWTACACS, EAD
By default, the IP address of TACACS accounting server is 0.0.0.0.
Note that:
You are not allowed to assign the same IP address to both primary and secondary
accounting servers; otherwise, unsuccessful operation is prompted.
If you repeatedly use this command, the latest configuration overwrites the
previous one.
You can remove an accounting server only when it is not being used by any active
TCP connections.
Example
# Configure a secondary accounting server.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] hwtacacs scheme test1
[3Com-hwtacacs-test1] secondary accounting 10.163.155.12 49

1.3.15 secondary authentication

Syntax
secondary authentication ip-address [ port ]
undo secondary authentication
View
HWTACACS scheme view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal format.
port: Port number of the server, which is in the range of 1 to 65535 and defaults to 49.
Description
Use the secondary authentication command to configure a secondary TACACS
authentication server.
Use the undo secondary authentication command to delete the configured
secondary server.
By default, the IP address of TACACS authentication server is 0.0.0.0.
Note that:
You are not allowed to assign the same IP address to both primary and secondary
authentication servers; otherwise, unsuccessful operation is prompted.
If you repeatedly use this command, the latest configuration overwrites the
previous one.
Chapter 1 AAA & RADIUS & HWTACACS
1-66
Configuration Commands