Rip Output - 3Com 7750 Series Command Reference Manual

3com switch command reference guide

Hide thumbs Also See for 7750 Series:

Table of Contents

3Com Switch 7750 Series

Command Reference Guide – Routing Protocol

value: Additional route metric added when transmitting a RIP route, ranging from 1 to

16. By default, the value is 1.

Use the rip metricout command to configure the additional route metric added to the

RIP routes to be transmitted on an interface.

Use the undo rip metricout command to restore the default value of this additional

route metric.

The metricout configuration only applies to the RIP routes learnt by the router and

those generated by the router itself. It does not apply to any route imported to RIP by

any other routing protocol.

Related command: rip metricin.

# Set the additional route metric added to the RIP routes to be transmitted on

Vlan-interface 10 to 2.

<3Com> system-view

System View: return to User View with Ctrl+Z.

[3Com] interface Vlan-interface 10

[3Com-Vlan-interface10] rip metricout 2

2.1.18 rip output

undo rip output

Interface view

Use the rip output command to enable an interface to transmit RIP packets.

Chapter 2 RIP Configuration Commands

Table of Contents