Apply Tag - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Routing Protocol
View
Route policy view
Parameter
igp: Specifies that BGP routing information source is internal route
egp: Specifies that BGP routing information source is external route
as-number: Specifies autonomous system number of external routes. The value
ranges from 1 to 65535.
incomplete: Specifies that BGP routing information source is unknown.
Description
Use the apply origin command to set BGP routing information source.
Use the undo apply origin command to cancel the apply statement setting.
Related command: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match cost, if-match tag, route-policy, apply ip next-hop, apply
local-preference, apply cost and apply tag.
Example
# Define an apply statement to specify that the BGP routing information source is igp.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com]route-policy 10 permit node 10
[3Com-route-policy] apply origin igp

6.1.9 apply tag

Syntax
apply tag value
undo apply tag
View
Route policy view
Parameter
value: Tag value of route information. The value ranges from 0 to 4294967295.
Description
Use the apply tag command to configure to set the tag area of RIP or OSPF route
information.
Use the undo apply tag command to cancel the apply statement.
Chapter 6 IP Routing Policy Configuration Commands
6-7