Port Isolate - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Port Isolation
This command functions the same as the 1.1.4 port isolate command except that
Ethernet ports must be specified in this command.
Example
# Add GigabitEthernet1/0/1 to isolation group 1.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] port-isolate group 1
[3Com-port-isolate-group1] port GigabitEthernet1/0/1

1.1.4 port isolate

Syntax
port isolate group-id
undo port isolate
View
Ethernet port view
Parameter
group-id: ID of an isolation group, in the range of 1 to 64.
Description
Use the port isolate command to add the current Ethernet port to the created isolation
group.
Use the undo port isolate command to remove the current Ethernet port from the
isolation group.
By default, an isolation group contains no port.
This command functions the same as the 1.1.3 port command except that Ethernet
ports need not be specified in this command.
Note:
An Ethernet port belongs to only one port isolation group. If you add an Ethernet port to
different isolation groups, the port belongs to only the latest isolation group to which the
port is added.
Example
# Add GigabitEthernet1/0/1 port to isolation group 1.
Chapter 1 Port Isolation Configuration Commands
1-3