Primary Accounting - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – AAA, RADIUS, HWTACACS, EAD
Related command: display radius and radius nas-ip.
Example
# Set the source IP address used by the switch to send the RADIUS packets to
10.1.1.1.
<3Com>system-view
System View: return to User View with Ctrl+Z.
[3Com] radius scheme test1
[3Com-radius-test1] nas-ip 10.1.1.1

1.2.11 primary accounting

Syntax
primary accounting ip-address [ port-number ]
undo primary accounting
View
RADIUS scheme view
Parameter
ip-address: IP address, in dotted decimal notation.
port-number: UDP port number, ranging from 1 to 65535.
Description
Use the primary accounting command to set the IP address and port number of the
primary RADIUS accounting server.
Use the undo primary accounting command to restore the default IP address and
port number of the primary RADIUS accounting server.
The IP address and UDP port number of the primary accounting server used by the
default RADIUS scheme "system" are 127.0.0.1 and 1646. The IP address and the
UDP port number of the primary accounting server used by a newly created RADIUS
scheme are 0.0.0.0 and 1813.
After creating a new RADIUS scheme, you should configure the IP address and UDP
port number of each RADIUS server you want to use in this scheme. These RADIUS
servers fall into two types: authentication/authorization, and accounting. And for each
kind of server, you can configure two servers in a RADIUS scheme: primary and
secondary servers.
In an actual network environment, you can configure the above parameters as required.
But you should configure at least one authentication/authorization server and one
accounting server. At the same time, you should keep the RADIUS service port settings
on the switch consistent with those on the RADIUS servers.
Chapter 1 AAA & RADIUS & HWTACACS
1-35
Configuration Commands