Packet-Filter - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – ACL
Table 1-3 Description of the fields of the display time-range command
Current
4-3-2003 Thursday
Time-range : tm1 ( Inactive )
from 08:30 2-5-2005 to 18:00
2/19/2005

1.1.11 packet-filter

Syntax
I. The command line format for A type card
packet-filter
[ not-care-for-interface ]
undo packet-filter { inbound | outbound } acl-rule [ not-care-for-interface ]
II. The command line format for the cards except A type ones
packet-filter inbound acl-rule [ system-index ]
undo packet-filter inbound acl-rule
Note:
Combined activating of IP ACL and Link ACL is supported by the cards except A type
ones. But the sum of the bytes number defined by IP ACL and that defined by the Link
ACL can not exceed 32 bytes; otherwise the ACL can not be activated.
View
QoS view
Parameter
inbound: Specifies to filter packets received on the port.
outbound: Specifies to filter packets sent through the port.
acl-rule: Applied ACL rules, which can be the combination of different types of ACL
rules. Table 1-4and Table 1-6 describe the ACL combinations on service board of A
type and the corresponding parameter description. Table 1-5 and Table 1-6 describe
Field
time is 14:36:36
{ inbound |
Description
The current time of the system.
Time range tm1. "Inactive" indicates that this
time range is currently in the inactive state (while
"Active" indicates that the time range is in the
active state), and the time range is from 8:30
February 5, 2005 to 18:00 February 19 2005.
outbound } acl-rule
1-10
Chapter 1 ACL Commands
[ system-index ]