Isis Authentication-Mode - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Routing Protocol
View
System view
Parameter
tag: Name of an IS-IS routing process, consisting of no more than 128 characters. Its
length can be 0, that is, the tag argument can be null.
Description
Use the isis command to start a corresponding IS-IS routing process and enter the
IS-IS view.
Use the undo isis command to delete the specified IS-IS routing process.
IS-IS routing processes are disabled by default.
Before running IS-IS protocol normally, you must first use the isis command to enable
IS-IS process, then use the network-entity command to configure a network entity
title (NET) for the router, and then use the isis enable command to enable each
interface that need to run the IS-IS process.
Note:
Only one IS-IS routing process can be enabled on a router.
Related command: isis enable, and network-entity.
Example
# Start the IS-IS routing process, with the system ID as 0000.0000.0002, and area ID
as 01.0001.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] isis
[3Com-isis] network-entity 01.0001.0000.0000.0002.00

4.1.18 isis authentication-mode

Syntax
isis authentication-mode { simple | md5 } password [ { level-1 | level-2 } [ ip | osi ] ]
undo isis authentication-mode { simple | md5 } password [ { level-1 | level-2 } [ ip
| osi ] ]
Chapter 4 Integrated IS-IS Configuration Commands
4-16