Mirroring-Group Reflector-Port - 3Com 7750 Series Command Reference Manual

3com switch command reference guide
Hide thumbs Also See for 7750 Series:
Table of Contents

Advertisement

3Com Switch 7750 Series
Command Reference Guide – Mirroring
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com]mirroring-group 1 monitor-slot 4

1.1.10 mirroring-group reflector-port

Syntax
mirroring-group group-id reflector-port reflector-port
undo mirroring-group group-id reflector-port reflector-port
View
System view/Ethernet port view
Parameter
group-id: Group number of a mirroring group, in the range of 1 to 20.
reflector-port reflector-port: Specifies the reflector port. reflector-port is available in
system view only.
Description
Use the mirroring-group reflector-port command to specify the reflector port.
Use the undo mirroring-group reflector-port command to remove the configuration
of the reflector port..
Note the following when you configure the reflector port:
The reflector port must be an Access port.
LACP must be disabled on the reflector port.
The reflector ports are mutually exclusive with STP or DLDP. That is, if STP or
DLDP is enabled on a port, you are not recommended to configure it as a reflector
port; you are not recommended to enable STP or DLDP on a reflector port.
After a port is configured as a reflector port, the switch does not allow you to
change the port type and its default VLAN ID, or to add it to another VLAN.
To mirror tagged packets, you need to configure VLAN VPN on the reflector port.
Example
# Configure GigabitEthernet1/0/2 as the reflector port.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] mirroring-group 1 reflector-port GigabitEthernet1/0/2
1-11
Chapter 1 Mirroring Commands

Advertisement

Table of Contents
loading

Table of Contents