Reset Garp Statistics - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide — GVRP Commands
Also note that this argument needs to be a multiple of 5 and cannot be larger than
32,765.
By default, the LeaveAll timer is set to 1,000 centiseconds (that is, 10 seconds).
Description
Use the garp timer leaveall command to set the GARP LeaveAll timer.
Use the undo garp timer leaveall command to restore the default setting of the GARP
LeaveAll timer.
Once a GARP entity starts up, it starts the LeaveAll timer, and sends out a LeaveALL
message after the timer times out, so that other GARP entities can re-register all the
attribute information on this entity. After that, the entity restarts the LeaveAll timer to
begin a new cycle.
Related command: display garp timer.
Example
# Set the GARP LeaveAll timer to 100 centiseconds.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] garp timer leaveall 100

1.1.5 reset garp statistics

Syntax
reset garp statistics [ interface interface-list ]
View
User view
Parameter
interface-list: List of Ethernet ports. You can specify multiple Ethernet ports by providing
this argument in the form of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } &<1-10>, where &<1-10> means that you can
provide up to 10 port indexes/port index lists for this argument.
Description
Use the reset garp statistics command to clear the GARP statistics (such as the
information about the packets received/sent/discarded by GVRP/GMRP) on specified
or all ports.
Executing the reset garp statistics command without any parameter clears the GARP
statistics of all ports.
Chapter 1 GVRP Configuration Commands
1-5