Undo Synchronization - 3Com 7750 Series Command Reference Manual

3com switch command reference guide

Hide thumbs Also See for 7750 Series:

Table of Contents

3Com Switch 7750 Series

Command Reference Guide – Routing Protocol

keepalive-interval: Set the interval time value for keepalive time. The range is 1 to

65535. By default, its value is 60 seconds.

holdtime-interval: Set the interval time value for hold time. The range is 3 to 65535. By

default, its value is 180 seconds.

Use the timer command to configure the Keep-alive and Hold-time timer of BGP.

Use undo timer command to restore the default value of the Keep-alive and

Hold-time of the timer.

# Configure the Keep-alive timer as 30 seconds and Hold-time timer as 90 seconds.

<3Com>system-view

System View: return to User View with Ctrl+Z.

[3Com] bgp 100

[3Com-bgp] timer keepalive 120 hold 360

5.1.64 undo synchronization

undo synchronization

Use the undo synchronization command to cancel the synchronization of BGP and

By default, BGP does not synchronize with IGP.

If the local BGP is not set synchronous with the IGP and the next hop of the learned

BGP route is reachable, the local BGP will add this BGP route into its routing table

immediately after it learns the route, rather than waiting till the IGP also learns the

This command means BGP does not synchronize with IGP in current system. You

need not configure it for Switch 7750 Series Ethernet Switches don't support

synchronization of BGP and IGP at present.

Chapter 5 BGP Configuration Commands

Table of Contents