Flow-Control; Flow-Control Enable - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide — Basic Port Commands
System View: return to User View with Ctrl+Z.
[3Com] interface GigabitEthernet1/0/1
[3Com-GigabitEthernet1/0/1] duplex full

1.1.10 flow-control

Syntax
flow-control
undo flow-control
View
Ethernet port view
Parameter
None
Description
Use the flow-control command to enable flow control on the port so as to avoid packet
loss during congestion.
Use the undo flow-control command to disable flow control on the port.
By default, flow control is disabled on a port.
Note:
Enable flow control on the port following the two steps:
Enable flow control globally;
Enable flow control on the port in Ethernet port view.
Example
# Enable flow control on the GigabitEthernet1/0/1 port.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] interface GigabitEthernet1/0/1
[3Com-Ethernet1/0/1] flow-control

1.1.11 flow-control enable

Syntax
flow-control enable
Chapter 1 Port Basic Configuration Commands
1-12