Qe Monitor Overflow-Threshold - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – System Maintenance & Debugging

3.1.19 qe monitor overflow-threshold

Syntax
qe monitor overflow-threshold threshold
View
System view
Parameter
threshold: Integer that sets the overall traffic threshold, ranging from 0 to 4294967295
(in bps).
Description
Use the qe monitor overflow-threshold command to specify the overall traffic
threshold used in queue traffic monitoring.
The overall traffic threshold defaults to 300,000,000 bps (300 Mbps).
With queue traffic monitoring enabled, the switch monitors the queue traffic and
relieves blocks in the output queue of its interfaces.
The criterion used to distinguish a block is that the queue is full and the traffic of the
corresponding interface is less than the specified threshold.
Example
# Set the overall traffic threshold used in queue traffic monitoring to 90 Mbps.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] qe monitor overflow-threshold 90000000
3.1.20 rdram
Syntax
rdram { enable | disable }
View
System view
Parameter
enable: Enables rambus dynamic random access memory (RDRAM) of the device.
disable: Disables RDRAM of the device.
Description
Use the rdram enable command to enable RDRAM of the device.
3-14
Chapter 3 Device Management
Commands