3Com 7750 Series Command Reference Manual page 166

3Com Switch 7750 Series
Command Reference Guide — Basic Port Commands
Input(normal):
Input:
Output(total): 1288 packets, 116919 bytes
Output(normal): - packets, - bytes
Output: 0 output errors,
Table 1-2 Description on the fields of the display interface command
Ethernet1/0/1 current state
IP Sending Frames' Format
Hardware address
The Maximum Transmit Unit
Media type
Port hardware type
Flow-control is enabled
The Maximum Frame Length
Allow jumbo frame to pass
Port monitor last value: 5
PVID
Mdi type
Port link-type
Tagged VLAN ID
Untagged VLAN ID
Last 300 seconds input: 0 packets/sec 0
bytes/sec
Last 300 seconds output: 0 packets/sec
0 bytes/sec
- packets, - bytes
- broadcasts, - multicasts, - pauses
- input errors, 0 runts, - giants,
0 frame, - overruns, - aborts, - ignored, - parity errors
0 broadcasts, 886 multicasts, 0 pauses
- broadcasts, - multicasts, - pauses
- underruns, - buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
- lost carrier, - no carrier
Field
Chapter 1 Port Basic Configuration Commands
0 throttles, 0 CRC
Enable/disable status of the current
Ethernet port
Ethernet frame format
Port hardware address
The maximum transmit unit (MTU)
Media type
Port hardware type
Flow-control status of the port
Maximum frame length allowed on the
port
Whether Jumbo frame is allowed on the
port.
Delay of reporting down state to the
system for a port
Default VLAN ID of the port
Network cable type
Port link type
Identify the VLANs whose packets will
be forwarded with tags on the port.
Identify the VLANs whose packets will
be forwarded without tags on the port.
Rate and number of incoming and
outgoing packets in the last 300 seconds
1-7
Description