Ospf Timer Retransmit; Ospf Trans-Delay - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Routing Protocol

3.1.40 ospf timer retransmit

Syntax
ospf timer retransmit interval
undo ospf timer retransmit
View
Interface view
Parameter
interval: Interval, in seconds, for retransmitting LSA on an interface. It ranges from 1 to
3600 and defaults to 5.
Description
Use the ospf timer retransmit command to configure the interval for LSA
retransmission on an interface.
Use the undo ospf timer retransmit command to restore the default interval value
for LSA retransmission on the interface.
If a router running OSPF transmits a "link state advertisement" (LSA) to the peer, it
needs to wait for the acknowledgement packet from the peer. If no acknowledgement
is received from the peer within the LSA retransmission interval, this LSA will be
retransmitted.
The LSA retransmit between adjacent routers should not be set too short; otherwise,
unexpected retransmission will occur (See RFC2328).
Example
# Specify the retransmit for LSA transmission between the interface Vlan-interface 10
and the adjacent routers to 12 seconds.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] interface Vlan-interface 10
[3Com-Vlan-interface10] ospf timer retransmit 12

3.1.41 ospf trans-delay

Syntax
ospf trans-delay seconds
undo ospf trans-delay
Chapter 3 OSPF Configuration Commands
3-46