Dot1X Guest-Vlan - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – 802.1x
undo dot1x dhcp-launch
View
System view
Parameter
None
Description
Use the dot1x dhcp-launch command to specify an 802.1x-enqbled switch to launch
the process to authenticate a supplicant system when the supplicant system applies for
a dynamic IP address through DHCP.
Use the undo dot1x dhcp-launch command to disable an 802.1x-enqbled switch from
authenticating a supplicant system when the supplicant system applies for a dynamic
IP address through DHCP.
By default, an 802.1x-enabled switch does not authenticate a supplicant system when
the latter applies for a dynamic IP address through DHCP.
Related command: display dot1x.
Example
# Configure to authenticate a supplicant system when it applies for a dynamic IP
address through DHCP.
<3Com>system-view
System View: return to User View with Ctrl+Z.
[3Com] dot1x dhcp-launch

1.1.5 dot1x guest-vlan

Syntax
dot1x guest-vlan vlan-id [ interface interface-list ]
undo dot1x guest-vlan vlan-id [ interface interface-list ]
View
System view, Ethernet port view
Parameter
vlan-id: VLAN ID of a Guest VLAN, in the range from 1 to 4,094.
interface-list: List of Ethernet ports, expressed as interface-list = { interface-name [ to
interface-name ] } & < 1-10 >. The interface-name argument is the port index of a port
and can be specified in this form: interface-name = { interface-type interface-num },
Chapter 1 802.1x Configuration Commands
1-7