Rip - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Routing Protocol
When you need to re-configure the parameters of RIP, you can use this command to
restore the default setting.
Example
# Reset the RIP system configuration.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] rip
[3Com-rip] reset
% Reset RIP's configuration and restart RIP? [Y/N]y

2.1.13 rip

Syntax
rip
undo rip
View
System view
Parameter
None
Description
Use the rip command to enable RIP and enter RIP view.
Use the undo rip command to disable RIP.
By default, the system does not run RIP.
RIP must be enabled before you can enter the RIP view and configure various RIP
global parameters. You can, however, configure the interface-based parameters
regardless of whether RIP is enabled.
Note:
Note that the interface parameters configured previously would be invalid when RIP is
disabled.
Example
# Enable RIP and enter RIP view.
<3Com> system-view
Chapter 2 RIP Configuration Commands
2-12