Vrrp Vrid Virtual-Ip - 3Com 7750 Series Command Reference Manual

3com switch command reference guide

Hide thumbs Also See for 7750 Series:

Table of Contents

3Com Switch 7750 Series

Command Reference Guide – VRRP & HA

[3Com] interface Vlan-interface 2

[3Com-Vlan-interface2] vrrp vrid 1 track vlan-interface 1 reduced 50

1.1.11 vrrp vrid virtual-ip

vrrp vrid virtual-router-id virtual-ip virtual-address

undo vrrp vrid virtual-router-id [ virtual-ip virtual-address ]

VLAN interface view

virtual-router-id: VRRP backup group ID ranging from 1 to 255.

virtual-address: Virtual router IP address to be configured.

Use the vrrp vrid virtual-ip command to add a virtual router IP address to an existing

backup group.

Use the undo vrrp vrid virtual-ip command to remove a virtual router IP address from

an existing backup group.

The vrrp vrid virtual-ip command can also be used to create a backup group. You can

add up to 16 virtual router IP addresses to a backup group. The undo vrrp vrid

virtual-ip command can also be used to remove an existing backup group. A backup

group is removed if all the virtual router IP addresses configured for it are removed.

Note that the virtual router IP address and the IP addresses used by the member

switches in a backup group must belong to the same network segment. If not, the

backup group will be in the initial state (the state before you configure the VRRP for the

switches). In this case, VRRP does not take effect.

# Create a backup group.

<3Com> system-view

System View: return to User View with Ctrl+Z.

[3Com] interface Vlan-interface 2

[3Com-Vlan-interface2] vrrp vrid 1 virtual-ip 10.10.10.10

# Add a virtual router IP address to an existing backup group.

[3Com-Vlan-interface2] vrrp vrid 1 virtual-ip 10.10.10.11

# Remove a virtual router IP address from a backup group.

[3Com-Vlan-interface2] undo vrrp vrid 1 virtual-ip 10.10.10.10

Chapter 1 VRRP Configuration Commands

Table of Contents