Route-Policy - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Routing Protocol
Example
# Define an ip-prefix named p1 to permit only the routes whose mask lengths are 17
or 18 on network segment 10.0.192.0 8 to pass.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] ip ip-prefix p1 permit 10.0.192.0 8 greater-equal 17 less-equal 18

6.1.22 route-policy

Syntax
route-policy route-policy-name { permit | deny } node { node-number }
undo route-policy route-policy-name [ permit | deny | node node-number ]
View
System view
Parameter
route-policy-name: Name of the Route-policy, containing 1 to 19 characters. It
identifies a Route-policy uniquely.
permit: Specifies the match mode of the defined Route-policy node as permit mode.
When a route entry meets all the if-match statements of the node, the entry is
permitted to filter through the node and the apply statement of the node will be
performed. If a route entry does not meet the if-match statement of the node, the next
node of the route-policy will be tested.
deny: Specifies the match mode of the defined Route-policy node as deny mode.
When a route entry meets all the if-match statements of the node, the entry is
prohibited from filtering through the node and the next node will not be tested.
node: Specifies the node of the route policy.
node-number: Index of the node in the route-policy. When this route-policy is used for
routing information filter, the node with smaller node-number will be tested first.
Description
Use the route-policy command to enter the Route-policy view.
Use the undo route-policy command to delete the created Route-policy.
By default, no Route-policy is defined.
Route-policy is used for route information filter or route policy. A Route-policy
comprises some nodes and each node comprises some if-match statements and
apply statements.
Chapter 6 IP Routing Policy Configuration Commands
6-19