Ntp-Service Unicast-Peer - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – NTP
Use the undo ntp-service source-interface command to cancel the current setting.
By default, the source address depends on the output interface.
You can use this command to designate an interface of which the IP address will be
the source IP address in all the NTP packets sent by the local device so that the
remote device sends the response message to this interface only.
Example
# Configure all the outgoing NTP packets to use the IP address of Vlan-Interface1 as
their source IP address.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] ntp-service source-interface Vlan-Interface 1

1.1.17 ntp-service unicast-peer

Syntax
ntp-service unicast-peer { ip-address | server-name } [ version number |
authentication-key keyid | source-interface interface-type interface-number |
priority ]*
undo ntp-service unicast-peer { ip-address | server-name }
View
System view
Parameter
ip-address: Specifies the IP address of a remote server.
server-name: Specifies the host name of an NTP server, containing 1 to 20 characters.
version: Defines an NTP version number.
number: NTP version number, ranging from 1 to 3.
authentication-keyid: Defines an authentication key.
keyid: Key ID used for transmitting messages to a remote server, ranging from 1 to
4,294,967,295.
source-interface: Specifies an interface name.
interface-type: Specifies the interface type and determines an interface together with
the interface-number parameter.
interface-number: Specifies the interface number and determines an interface together
with the interface-type parameter.
priority: Designates a server as the first choice.
Chapter 1 NTP Configuration Commands
1-14