Display Multicast-Source-Deny - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Multicast
Table 2-4 Description on the fields of the display multicast routing-table command
Multicast Routing Table
Total 3 entries
(4.4.4.4, 224.2.149.17)
Uptime: 00:15:16, Timeout in 272 sec
Upstream
Vlan-interface1(4.4.4.6)
Downstream interface list:
Vlan-interface2(2.2.2.4),
0x1: IGMP
Matched 3 entries

2.1.5 display multicast-source-deny

Syntax
display multicast-source-deny [ interface interface-type [ interface-number ] ]
View
Any view
Parameter
interface-type: Port type.
interface-number: Port number.
Description
Use the display multicast-source-deny command to display the configuration
information about the multicast source port check.
When you use this command to display the information,
If you specify neither the port type nor the port number, the multicast source port
check information about all the ports on the switch is displayed.
If you specify the port type only, the multicast source port check information about
all ports of this type is displayed.
Chapter 2 Common IP Multicast Configuration Commands
Field
interface:
Protocol
2-8
Description
Multicast routing table
There are 3 entries in all in the multicast
routing table.
(s,g) of the multicast routing table
The entry is up for 15 minutes and 16
seconds, and it times out in 272 seconds.
The IP address of the upstream interface
is 4.4.4.6.
Downstream interface list:
The IP address of the downstream
interface is 2.2.2.4.
The downstream interface is added by
the IGMP protocol.
Three entries match the configuration.