3Com 7750 Series Command Reference Manual page 314

3Com Switch 7750 Series
Command Reference Guide – Routing Protocol
View
Any view
Parameter
protocol: You can provide one of the following values for this argument.
direct: Displays direct-connect route information
static: Displays static route information.
bgp: Displays BGP route information
isis: Displays IS-IS route information.
ospf: Displays OSPF route information.
ospf-ase: Displays OSPF ASE route information.
ospf-nssa: Displays OSPF NSSA route information.
rip: Displays RIP route information.
inactive: With this argument provided, this command displays the inactive route
information. Without this argument provided, this command displays both active and
inactive route information.
verbose: With this argument provided, this command displays the verbose route
information. Without this argument provided, this command displays route summary
only.
Description
Use the display ip routing-table protocol command to display the route information
of a specific protocol.
Example
# Display the summary of all direct-connect routes.
<3Com> display ip routing-table protocol direct
DIRECT Routing tables:
Summary count: 8
DIRECT Routing table status:<active>:
Summary count: 7
Destination/Mask
10.5.1.0/24
10.5.1.5/32
100.100.1.1/32
102.1.1.0/24
102.1.1.1/32
127.0.0.0/8
127.0.0.1/32
DIRECT Routing table status:<inactive>:
Chapter 1 Static Route Configuration Commands
Protocol Pre Cost
DIRECT 0 0
DIRECT 0 0
DIRECT 0 0
DIRECT 0 0
DIRECT 0 0
DIRECT 0 0
DIRECT 0 0
1-10
Nexthop Interface
10.5.1.5 Vlan-interface105
127.0.0.1 InLoopBack0
127.0.0.1 InLoopBack0
102.1.1.1 LoopBack1
127.0.0.1 InLoopBack0
127.0.0.1 InLoopBack0
127.0.0.1 InLoopBack0