Radius Nas-Ip - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – AAA, RADIUS, HWTACACS, EAD
accounting server. At the same time, you should keep the RADIUS service port settings
on the switch consistent with those on the RADIUS servers.
Related command: key, radius scheme and state.
Example
# Set the IP address and UDP port number of the primary authentication/authorization
server used by the RADIUS scheme radius1 to 10.110.1.1 and 1812.
<3Com>system-view
System View: return to User View with Ctrl+Z.
[3Com] radius scheme radius1
[3Com-radius-radius1] primary authentication 10.110.1.1 1812

1.2.13 radius nas-ip

Syntax
radius nas-ip ip-address
undo radius nas-ip
View
System view
Parameter
ip-address: Source IP address, in dotted decimal notation.
Description
Use the radius nas-ip command to set the source address used by the NAS to send
RADIUS packets.
Use the undo radius nas-ip command to restore the default setting.
By default, no source address is specified, and the address of the outbound interface is
used as the source address of the packet.
Note:
The nas-ip command in RADIUS scheme view has the same function as the radius
nas-ip command in system view; and the priority of configuration in RADIUS scheme
view is higher than in system view.
Note that:
Chapter 1 AAA & RADIUS & HWTACACS
1-37
Configuration Commands