Display Bgp Routing-Table Different-Origin-As - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Routing Protocol
Table 5-8 Description on the fields of the display bgp routing-table dampened
command
Field
Flags
#D
Dest/Mask
Source
Damping-limit
Origin
As-path

5.1.21 display bgp routing-table different-origin-as

Syntax
Display bgp [ multicast ] routing-table different-origin-as
View
Any view
Parameter
multicast: Specifies multicast address family.
Status code:
# – valid (valid route)
^ – active (optimal route selected)
I – internal (IBGP route)
D – damped
H – history
S – aggregate suppressed
B – balance (load balance)
Valid and dampened route
The route to this network segment is dampened.
Next hop of the route
Time when damping is invalid, that is, time when the route can be
reused.
The ORIGIN attribute of the route, which indicates the routing update
origination of the route relative to the AS the route sourced from. It can
be one of the three value:
This is an AS interior route. BGP regards both aggregated
IGP routes and routes defined by the network command as AS
interior routes and set their origin type to IGP.
EGP This route is learned from EGP (exterior gateway protocol).
INCOMPLETE: indicates the route is obtained from an
unknown source (that is, learned from a different source). BGP
INC
set the origin of the routes imported from other IGP protocols to
INCOMPLETE
AS_PATH attribute of the route, which records all the ASs the route
passes through and can be used to avoid route ring.
5-21
Chapter 5 BGP Configuration Commands
Description