Port-Security Timer Disableport - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Port Security & Port Binding
Note:
When a port works in the userlogin-secure-else-mac-ext mode or the
userlogin-secure-else-mac mode, for the same packet, intrusion protection can be
triggered only after both MAC authentication and 802.1x authentication fail.
By default, no security mode is set on the port.
Example
# Enter system view.
<3Com> system-view
System View: return to User View with Ctrl+Z.
# Enable port security.
[3Com] port-security enable
# Enter GigabitEthernet1/0/1 port view.
[3Com] interface GigabitEthernet1/0/1
# Set the security mode on GigabitEthernet1/0/1 to userlogin.
[3Com-GigabitEthernet1/0/1] port-security port-mode userlogin

1.1.9 port-security timer disableport

Syntax
port-security timer disableport timer
undo port-security timer disableport
View
System view
Parameter
timer: This argument ranges from 20 to 300 and defaults to 20 (in seconds).
Description
Use the port-security timer disableport command to set the time during which the
system temporarily disables a port.
Use undo port-security timer disableport command restore the default time.
Chapter 1 Port Security Commands
1-13