3Com 7750 Series Command Reference Manual page 244

3Com Switch 7750 Series
Command Reference Guide – MAC Address Table
dynamic: Specifies that the MAC address entry to be added/updated is of dynamic
type.
mac-address: MAC address.
interface-type: Port type.
interface-number: Port number.
vlan-id: VLAN ID. This argument ranges from 1 to 4094.
mac-address-attribute: String used to specify the MAC address entries to be removed,
as described in Table 1-3.
Table 1-3 Description on the mac-address-attribute argument
{ static | dynamic } interface
interface-type interface-number
{ static | dynamic } vlan vlan-id
{ static | dynamic } mac-address
[ interface
interface-number ] vlan vlan-id
interface
interface-number
vlan vlan-id
mac-address
interface-type
vlan vlan-id
Description
Use the mac-address command to add/modify a MAC address entry.
Use the undo mac-address command to remove one or more MAC address entries.
If the MAC address you input in the mac-address command already exists in the MAC
address table, the system will modify the attributes of the corresponding MAC address
entry according to your settings in the command.
You can remove all MAC address entries (unicast MAC addresses only) concerning a
specific port, or remove a specific type of MAC address entries, such as the addresses
learnt by the system and dynamic or static MAC address entries configured.
Example
# Configure a static MAC address entry with the following settings:
Value
interface-type
interface-type
[ interface
interface-number ]
1-5
Chapter 1 MAC Address Table Configuration
Description
Removes the static or dynamic MAC
address entries concerning a specified port.
Removes the static or dynamic MAC
address entries concerning a specified
VLAN.
Removes a specified static or dynamic MAC
address entry.
Removes all the MAC address entries
concerning a specified port.
Removes all the MAC address entries
concerning a specified VLAN.
Removes a specified MAC address entry.
Commands