Reset Udp-Helper Packet - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – UDP Helper
Description
Use the display udp-helper server command to display the information about the
configured destination servers connected to a specified VLAN interface and the
number of the packets forwarded to each destination server. If you do not specified the
vlan-id argument, the corresponding information about all the VLAN interfaces is
displayed.
Example
# Display the information about the configured destination servers connected to VLAN
1 interface and the number of the packets forwarded to the destination servers.
<3Com> display udp-helper server interface Vlan-interface 1
Interface name
Vlan-interface1
The information above shows that the server with its IP address being 192.1.1.2 is
configured as a destination server and is connected to VLAN 1 interface, and no
packets are forwarded to it so far.

1.1.3 reset udp-helper packet

Syntax
reset udp-helper packet
View
User view
Parameter
None
Description
Use the reset udp-helper packet command to clear the statistics about the packets
forwarded by UDP-Helper.
Example
# Clear the statistics about the packets forwarded by UDP-Helper.
<3Com> reset udp-helper packet
udp-helper enable
Syntax
udp-helper enable
undo udp-helper enable
Chapter 1
Server address
192.1.1.2
1-2
UDP-Helper Configuration Commands
Packets sent
0