Reset Isis Peer; Set-Overload - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Routing Protocol
<3Com> reset isis all

4.1.35 reset isis peer

Syntax
reset isis peer system-id
View
User view
Parameter
system-id: System ID for an IS-IS peer, in the range of one bit to 128 bits.
Description
Use the reset isis peer command to clear the data information of a specific IS-IS
peer.
The IS-IS peer is not cleared by default.
This command is used when you need to re-establish a specific peer.
Example
# Clear the IS-IS peer with system ID as 0000.0c11.1111.
<3Com> reset isis peer 0000.0c11.1111

4.1.36 set-overload

Syntax
set-overload
undo set-overload
View
IS-IS view
Parameter
None
Description
Use the set-overload command to set overload flag for the current router.
Use the undo set-overload command to clear overload flag.
No overload flag is set by default.
Chapter 4 Integrated IS-IS Configuration Commands
4-31