Primary Authorization - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – AAA, RADIUS, HWTACACS, EAD
You can remove an authentication server only when it is not being used by any
active TCP connections, and the removal impacts only packets forwarded
afterwards.
Related command: display hwtacacs.
Example
# Configure a primary authentication server.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] hwtacacs scheme test1
[3Com-hwtacacs-test1] primary authentication 10.163.155.13 49

1.3.10 primary authorization

Syntax
primary authorization ip-address [ port ]
undo primary authorization
View
HWTACACS scheme view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal format.
port: Port number of the server, which is in the range 1 to 65535 and defaults to 49.
Description
Use the primary authorization command to configure a primary TACACS
authorization server.
Use the undo primary authorization command to delete the configured primary
authorization server.
By default, the IP address of TACACS authorization server is 0.0.0.0.
Note that:
You are not allowed to assign the same IP address to both primary and secondary
authorization servers; otherwise, unsuccessful operation is prompted.
If you repeatedly use this command, the latest configuration overwrites the
previous one.
You can remove an authorization server only when it is not being used by any
active TCP connections, and the removal impacts only packets forwarded
afterwards.
Related command: display hwtacacs.
Chapter 1 AAA & RADIUS & HWTACACS
1-62
Configuration Commands